State Feedback Control System of a Bar and Beam Using Emulated Hardware in the Loop (HIL)
Published in International Review of Automatic Control (IREACO) 8, 2015
Recommended citation: Caceres, C., Mora, J., Amaya, D., State Feedback Control System of a Bar and Beam Using Emulated Hardware in the Loop (HIL), (2015) International Review of Automatic Control (IREACO), 8 (1), pp. 32-38. doi:https://doi.org/10.15866/ireaco.v8i1.5135 https://www.praiseworthyprize.org/jsm/index.php?journal=ireaco&page=article&op=view&path[]=16586
Nowadays due to new technologies, many tools facilitate analysis and control of any system. Among the most used tools, exists the embedded systems, as a way of systems emulating under the concept of HIL (Hardware in-the loop); allowing quick and economic development of any type mechatronic product. This paper shows the results obtained in the design and development of control strategies for a process bar and ball, and this dynamic was implemented thought an ARM system, under the concept presented in this work HIL. In this model the variables analyzed where position, speed, angular position and angular velocity; additionally a 2D virtual environment was presented showing the operation of the bar-ball system according to an input signal obtained from the PC was implemented.
Recommended citation: Caceres, C., Mora, J., Amaya, D., State Feedback Control System of a Bar and Beam Using Emulated Hardware in the Loop (HIL), (2015) International Review of Automatic Control (IREACO), 8 (1), pp. 32-38. doi:https://doi.org/10.15866/ireaco.v8i1.5135